Solar Panel
- Maximum Power (P max): 20 W
- Voltage at Pmax (V mp): 17.3 V
- Current at Pmax (IMP): 1.16 A
- Short-Circuit Current (Isc): 1.29 A
- Open-Circuit Voltage (Voc): 21.6 V
Solid State Regulator
Electrical Specifications:
- Voltage: 12V
- Rated Solar Input: 10A
- Rated Load Current: 10A
- Equalization Voltage: 14.8V
- Boost Battery: 14.4V
- Float Battery: 13.6V
- Low Voltage Disconnect: 11.1V
- Low Voltage Reconnect: 13.1V
- Self-Consumption: 6 mA
- Operating Temp. -35 to +55ºC
Traffic Hazard Beacons
Polycarbonate Housing:
- 12” light housing plastic injected molded polystyrene tufen u.v. impregnated material for ultra violet rays
LED:
- Color: Yellow/Amber
- Applied Voltage: 12VDC
- Power Consumption (watts): 5
- • Dominant Wavelength (nm): 592
- On Axis Luminous Intensity (Min): 350 cd
- LEDs per signal lamp: 121
- Intensity loss due to single LED failure: 1.21%
- Operation Temperature: -40°F to +165°F
- Solid State Flasher/Timer Delay
- Input voltage of 12 VDC
- Flash rate 60 F.P.M.
- Flash Delay can be set from 5-1270 seconds
- Input voltage of 12 VDC (2 terminals)
- Two outputs of 12 VDC (4 terminals)
- Capable of switching 5 amps @ 12 VDC
- Input and output terminals 1/4 male quick connect
- Epoxy encapsulated construction
- Flasher is 4″ x 2″, two outer mounting holes
Control Cabinet/Battery
- Cabinet is 24” x 15” x 9”, .080, aluminum, “lockable”, to be located per state specifications.
- Recommended battery shall be 100 amp deep cycle marine. (Options Available)
- Signage and pole. (Options Available)
K & K Systems Transmitters
- Size: 4 ½” x 2 3/8” x 7/8”
- Range: 500 ft line of sight
- Antenna: Ferrite
- Output: 1.0 mW.
- Frequency: 26.995 MHz. Crystal
- Power: 9VDC NEDA battery
- Current Consumption: +20mA
- No. Codes: 6,561 in trinary format
- Case: ABS Crushproof plastic
K & K Systems Receivers
- Size: 3 1/8” x 2 ½” x 2” (base included)
- Antenna: Tuned 26.995 MHz. Ground-plane
- Output: Relay 1A. at 120 VAC, 2A. at 30 VDC
- Power: 11.8 – 26.0 VDC or 17.8 – 26.0 VDC
- Current Consumption: 30mA. Idle, 60 mA. Alarm
Push Button Assembly
- 2” Button with momentary switch rated at 36VDC
- 5” x 7” button fixture with crossing sign inserted